Bonhams Cars : 1964 CHEETAH GT COUPE (2024)

336ci OHV V8 Engine
Rochester Fuel Injection
400+ bhp at 6,900rpm
4-Speed Manual Transmission
4-Wheel Coil-Over Suspension
4-Wheel Drum Brakes

*Full restoration to vintage specs and livery
*One of only 11 completed cars from Bill Thomas
*Documented history and FIA Historic Technical Passport
*An icon of the California sports car scene

The Cheetah Sports Car

No one area of America is more passionate about automobiles than Southern California. And no product of the Southland's car culture more vividly represents those passions than does the Cheetah.

Conceived as a competitor to Ford's Cobra and built out of a small shop in Anaheim, Orange County in limited numbers from 1963 to 1965, the tube-framed fiberglass-bodied coupe was both crude and sophisticated, and its beastly behavior often mocked its curvaceous beauty. But, wherever it appeared — cruising down the boulevard or mixing it up with the eclectic sports car grids of the day — the Cheetah's Corvette-engined roar and extreme bodywork turned even graybeard heads, who thought they'd seen it all, and made young boys rush out to buy Cheetah slot cars for their collections.

If nothing else, the Cheetah story is about what might have been. Had its entrepreneurs of speed, Bill Thomas and Don Edmunds, been as well funded as, for example, Lance Reventlow and his Scarab or Carroll Shelby and his Cobra, or had Chevrolet deigned to continue its support of the project it had help spawn, the Cheetah story might have turned out far differently.

Bill Thomas grew up in Southern California and, in 1956, began his lifelong tinkering with cars by massaging Corvettes for road racing. By 1960 he'd opened Bill Thomas Race Cars, where his stellar work attracted the attention of the racing mavens at Chevrolet. Among his many commissions while a part of the bowtie brigade were performance mods for the Corvair, Chevy II, BelAir and Biscayne, and development of the Louis Unser stock car that took a division crown at Pikes Peak.

Then, in 1963, in response to Ford's Cobra program, Thomas was asked to develop the car that would be called the Cheetah. Because GM's board had suspended all factory race programs and the Chevrolet could not openly support the project, it did supply the Corvette powertrain and other bits that found their way into the Cheetah. The back-door brief called for 100 examples to meet FIA homologation, though just 11 cars were completed before Chevrolet cancelled its unofficial support when the FIA increased homologation numbers to 1,000 units for the production classes.

The first two of those 11 Cheetahs, prototypes meant to impress the Chevy powers and investors in the project, were clad in aluminum bodies by California Metal Shaping from a wooden buck build by Edmunds. Aircraft Windshield was contracted to supply the windows. Subsequent models sported fiberglass bodies molded by Contemporary Fiberglass.

Chassis engineering and styling fell to Thomas employee Don Edmunds (who soon after left to form his own firm, Autoresearch, the noted purveyor of open-wheel race cars). As computer-aided design was still in an unimagined future, Edmunds simply drew up what looked and felt right. His tubular steel frame supporting the Corvette powertrain and suspension certainly looked the part of a proper cage, but it lacked the torsional rigidity needed for track use — the Cheetah was, after all, an exercise in what could be achieved with Chevy's full backing and was never, as delivered, a fully developed competition machine. To reduce the chassis' flexibility, most Cheetah owners that raced their cars added a variety of gussets and triangulated elements.

The front suspension consisted of upper and lower tubular A-arms, while the rear configuration, though based on the Corvette's, was augmented with fork-shaped trailing arms. Monroe coilover spring/shocks were used at all four corners, and heim joints replaced all ball joints. Though the Cheetah's overall weight was around 1,700 pounds, Chevy drum brakes were little more than adequate to halt the progress of this extremely fast machine. American Racing supplied the five-spoke magnesium wheels.

The chassis might have been an underachiever, but the Thomas Corvette 327 small-block V-8 combined the legs of its namesake — 215 mph at Daytona and 185 mph at Road America — with the brawn of an angry grizzly bear. Thomas tweaked the engine with the usual measures to increase air and fuel flows, including a 0.75-inch stroker crank and his innovative dual air meter Rochester fuel-injection system. Output of the 377 cubic inches easily exceeded 500 horsepower and could smoke the competition on a road course (in a straight line, at least) or a dragstrip.

Perhaps the most innovative, and problematic, design feature of the Cheetah was Edmunds effort to create perfect weight balance. The engine was set far back in the chassis, and the Muncie 4-speed transmission was connected directly to the Corvette IRS without the need for a driveshaft. Because the driver's legs were next to the engine, and Edmund's custom headers were just above both driver and passenger legs, the cockpit was a furnace. Some owners added air scoops to the tops of the gullwing doors for cooler interior temps, and one car even had its roof removed and still exists in roadster form.

The Cheetah recorded a checkered race history (11 victories across several race series), burdened by various shunts and mechanical ailments, but no one who saw it run as expected will ever forget the V-8's shattering rumble or the visceral appeal of the sensuous bodywork. An icon of a cottage industry that has passed into history, the Cheetah is a rare and remarkable example of an almost overwhelming power-to-weight ratio, the kind that sets racers pulses beating at max rpm.

The Cheetah's short production life ended from a combination of the FIA homologation rules change, being outpaced by new race technology, and a fire at Bill Thomas's shop. Thankfully, the Cheetahs that remain have not been hidden away in collections but continue to be shown and raced, making a new generation of gray beards nod in memory of the boys they once were and their slot-car dreams.

Designed to be a GT car, but because 100 never were produced, instead of competing against Cobras and Stingrays it had to race against King Cobra/Cooper Ford, Chaparral, McLaren, Ferrari, Lola and Lotus 19, 23, and 30. In SCCA it raced in C/Modified instead of A/Production.

The Motorcar Offered

This is the fourth customer-delivered fiberglass-bodied Cheetah and second in the series of three delivered to Alan Green Chevrolet in Seattle, Washington. Green bought two of the three for competition (one was destroyed at Daytona in February, 1964), but this is the only one of his Cheetahs to go road racing, accruing an outstanding documented record that included ten FIA events in 1964-65. The drivers who braved the Cheetah's edgy performance included Jerry Grant, Allen Grant, Don Jansen, Gary Gove, and Larry Webb, wrestling it around tracks all over America and Canada.

When first delivered, the car was red and without the rear fender flares that later would be fitted after the FIA dictated the modification to reduce the amount of track debris being thrown by the big rear tires. After being given Alan Green graphics and the number '8', it ran for the first time at a California Sports Car Club event at Pomona in 1964. Several months later Green repainted the car his signature green. As well as going road racing, the car was taken to the drags and recorded a 134 mph run in the mid 10-second range.

Subsequent owners raced this car in various guises and prevailed in several SCCA Regional championships, and then, in 1972, its new owner decided to turn it into a legal street car. Some confusion as to this car's identity has occurred because that owner stamped his own "serial number", BTC003, into the frame in order to register it for street use. In actuality, none of the five Cheetahs raced in period had numbers on the frame, so there is still some dispute about how many unfinished chassis and bodies were produced in addition to the 11 completed cars.

In 1989 the current owner purchased the street-modified Cheetah and was determined to take the car vintage racing, so he removed the original body and replaced it with a never-used one that he had painted red and restored to Alan Green's 1964 livery. The car then was vintage raced for the next 21 years, including more than ten times at the Monterey Historics where, in 1993, it received a class trophy. This Cheetah also won the USRRC Seniors Tour Series, Entrepreneur's Cup, in 1994.

In 2012, the current owner decided to remove the replacement body and remount the original body with 1965's livery while also installing a modern wiring harness and rebuilding the dual-meter Rochester fuel-injection unit. Ready to race, this Cheetah is offered with an abundance of documentation, a manual for the fuel-injection system, a wiring diagram, a FIA Historic Technical Passport, a California title and street license, correspondence and ownership documentation from prior owners, and a presentation book.

In addition to the FIA race history as provided in the catalogue description, a more comprehensive listing of FIA race events is available to prospective buyers upon request.

This is a rare chance to own an uncommon and notable icon of 1960's sports car entrepreneurship.

Bonhams Cars : 1964 CHEETAH GT COUPE (2024)

FAQs

How many Chevrolet Cheetahs were built in 1964? ›

GM's upper management squelched Chevy's back-door tech assistance to Bill Thomas' Cheetah program, and his Anaheim, California, shop suffered a fire, trashing his production tooling after only 21 cars were built. (13 of those are known to have survived.)

How much is the cheetah kit car? ›

Shell Valley sells Cheetahs in kit and turnkey-minus form. The latter versions are assembled at Shell Valley East, and start at $26,900 painted in your choice of colors and striping. All you add are the engine, tranny and driveshaft. Kits start at $15,990, so the choice is up to you.

How much horsepower does a Chevy Cheetah have? ›

The Thomas-modified V-8s in the Cheetah made anywhere from 465 to 520 horsepower, which was way more than the 289s found in the Cobra. And with a weight of just 1,550 pounds, it was around 450 pounds lighter than the Shelby as well. One Cheetah was even reportedly clocked at 215 mph at Daytona.

What was the top speed of a 1964 Cheetah? ›

For decades the Cheetah has been a bit of legend over in California, and with good reason. It all starts with these two statistics: 500+ horsepower in 1,500 pounds of weight. There's this as well: 215 mph at Daytona in 1964, and nearly 200 mph at Riverside, a much shorter track.

What engine was in the Cheetah? ›

Using his racing connections, Thomas arranged for material assistance from Chevrolet for the major components - the Corvette 327 engine, Muncie transmission, and independent rear-end assemblies.

What was the fastest Chevy? ›

The Exorcist Camaro ZL1 by Hennessey Performance

The tuning experts at Hennessey Performance took a look at the Chevrolet Camaro ZL1 and decided to do what Chevy couldn't: crack 200 mph by creating the Exorcist.

Is a cheetah faster than any car? ›

Cheetahs are faster than cars in terms of their maximum speed, but cars are quicker than cheetahs in terms of their acceleration and ability to reach high speeds quickly. The cheetah is the fastest land animal, capable of reaching speeds of up to 70 miles per hour (112 kilometers per hour) over short distances.

What car is the Cobra killer? ›

Chevrolet Cheetah 1964, also know as ''Killer Cobra''

How much does the cheetah car weigh? ›

The Cheetah only weighed around 1700 lbs, which made it amazingly quick, but with a short wheelbase and all that horsepower, its handling was unruly. Interestingly the engine, gearbox, and differential are all bolted directly to each other—this car has no driveshaft or torque tube.

What car is Cheetah in real life? ›

The HD Universe rendition of the Cheetah is primarily based on the Ferrari Enzo, with major elements taken from the Pagani Zonda. The carbon fibre stripe on the bonnet resembles that of the Pagani Zonda Tricolore.

What is a Chevy Cheetah? ›

According to legend, the Cheetah's body design was hastily sketched out on a cocktail napkin, yet it is one of the sexiest, most indelible racecars to come out of the early 1960s. The first two bodies were built in aluminum, while the “production” cars used fiberglass.

How many cheetahs were there in 2000? ›

Dipping from roughly 1,200 animals in 2000 to around 170 in 2016, according to a new study in the Proceedings of National Academy of Sciences.

What cars did Chevrolet make in 1964? ›

Select a 1964 Chevrolet Model
  • 1964 Bel Air.
  • 1964 Biscayne.
  • 1964 C10.
  • 1964 C20.
  • 1964 C30.
  • 1964 Chevelle 300.
  • 1964 Chevelle Malibu.
  • 1964 Chevelle Malibu Super Sport.

What was the population of cheetahs in 1960? ›

While there were perhaps 40,000 wild cheetahs in 1960, there were reportedly fewer than 20,000 by 1975, and of those, fewer than 3,000 in Africa's protected areas (Myers, 1975; Chapter 19).

What was the fastest car in the world in 1964? ›

1964 | Ferrari 500 Superfast | 171 mph (275 km/h)

Top Articles
Latest Posts
Recommended Articles
Article information

Author: Kerri Lueilwitz

Last Updated:

Views: 5916

Rating: 4.7 / 5 (47 voted)

Reviews: 94% of readers found this page helpful

Author information

Name: Kerri Lueilwitz

Birthday: 1992-10-31

Address: Suite 878 3699 Chantelle Roads, Colebury, NC 68599

Phone: +6111989609516

Job: Chief Farming Manager

Hobby: Mycology, Stone skipping, Dowsing, Whittling, Taxidermy, Sand art, Roller skating

Introduction: My name is Kerri Lueilwitz, I am a courageous, gentle, quaint, thankful, outstanding, brave, vast person who loves writing and wants to share my knowledge and understanding with you.